We were on the same machine for years. It still worked but it was time. Switched to this one and it’s been good. Takes a couple tires to get used to it and then you’re fine.

Had a wiring question setting it up. Called in and got it figured out. No problems after that.

Got the machine set up and put it straight to work. No issues. Bead breaker’s got plenty of power and it’s been doing what we need it to do every day.

We do a lot of low profile stuff and nicer wheels. We’ve been running an older Coats for a while and decided to replace it. Rey put us onto this one. Takes a few sets to get used to it but after that it’s simple and you’re not stressing about the wheels.

Wasn’t trying to spend big money on a lift, so we took a shot on this one. Got it set up and put a truck on it first day, felt solid. Been using it ever since.

We’ve run a good amount of tires through it already and it’s been fine. No issues. It’s just easier than what we had before. You’re not fighting it all the time and it’s more consistent.

Had one on order somewhere else and it kept getting pushed back. Canceled it and went this route. Had it that same week, everything was there, got the lift set up and started running cars on it.

Did a couple sets the first day just to get a feel for it. After that it was pretty straightforward. Not messing with it as much as we were before.